fraisa.com 860 Application technology information Tools with face fi nishing cutting edge: Radial cutting depth aemax for plane surfaces with tools with a face fi nishing cutting edge AX tools: Axial infeed depth aplim for plane transition in wall for AX Clean transitions can be achieved with the AX tools during fi nishing by means of several infeed depths. However, in this application the correct infeed depth is important. On the basis of the tool geometry with front radius, the limited axial infeed (aplim) is specifi ed in the following table: d1 l2 Radius r aplim Radius r aplim Radius r aplim Radius r aplim Radius r aplim Radius r aplim [mm] [mm] [mm] [mm] [mm] [mm] [mm] [mm] [mm] [mm] [mm] [mm] [mm] [mm] 34 0.5 2.5 45 0.5 3.5 56 0.5 4.5 67 0.5 5.5 1.0 5.0 2.5 3.5 8 9 1.0 7.0 2.5 5.5 10 11 1.0 9.0 1.5 8.5 2.5 7.5 4.0 6.0 12 13 1.0 11.0 1.5 10.5 2.5 9.5 4.0 8.0 16 18 1.0 16.0 1.5 15.5 2.0 15.0 2.5 14.5 4.0 13.0 20 22 1.0 20.0 1.5 19.5 2.0 19.0 2.5 18.5 4.0 17.0 25 27 1.0 25.0 1.5 24.5 2.5 23.5 4.0 22.0 d1 h b c aemax [mm] [mm] [mm] [mm] [mm] 3 0.02 0.1 0.20 2.6 4 0.02 0.1 0.20 3.6 5 0.02 0.1 0.20 4.6 6 0.03 0.2 0.20 5.3 8 0.03 0.2 0.35 7.3 10 0.04 0.3 0.35 9 12 0.04 0.3 0.50 11 16 0.04 0.3 0.50 15
RkJQdWJsaXNoZXIy MzQyNTY4Mg==